Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Kenmore?
Garage door work in Kenmore typically runs $150 – $600, with the exact price depending on what’s broken and which parts are involved. A single spring repair usually lands at $180 – $340, a new opener installed is often $250 – $550, and a full new door installation typically comes in at $700 – $2200. Every number here is an estimate for the Kenmore market in 2026; the written quote you get before work starts sets the final price.
We’re Renton Garage Door Repair Pros, and the calls we take from Kenmore homeowners usually fall into one of a few familiar patterns: a door that won’t close at bedtime, an opener that hums but doesn’t lift, or a panel that’s been dented since the last windstorm off Lake Washington. We work on eight major brands, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, so whatever hardware is bolted to your ceiling, our technicians have handled it. Call (833) 508-9224 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Most garage door repair jobs in Kenmore land between $150 and $600.
- Spring repair is the single most common call, at a typical $180 – $340 for one spring.
- Openers, cables, and panels each have their own price band, laid out below.
- A new door, start to finish, typically runs $700 – $2200 in the Kenmore market.
- Estimates are free, and the written quote is the price you pay.
Garage Door Cost Breakdown (2026)
Here’s what the main jobs cost in Kenmore right now. These are typical estimated ranges, not flat rates, because two doors with the same symptom can need very different parts.
| Job | Typical Estimated Range | What It Covers |
|---|---|---|
| Garage door repair (general) | $150 – $600 | Diagnosis and fix for the common failure points: springs, cables, tracks, rollers, hinges |
| Spring repair (one spring) | $180 – $340 | Single torsion or extension spring replacement; a matched pair usually runs about twice this |
| Cable repair | $130 – $250 | Lift cable replacement and re-tensioning |
| Opener repair | $120 – $320 | Motor, gear, logic board, remote, and connectivity troubleshooting |
| Opener installation | $250 – $550 | New opener mounted and wired, remotes and keypad programmed |
| Panel replacement | $250 – $500 | Replacing a damaged section without changing the whole door |
| Track realignment | $120 – $240 | Straightening tracks and resetting rollers so the door travels clean |
| Roller replacement | $110 – $220 | New rollers throughout; quiets a door that shudders or grinds |
| New door installation | $700 – $2200 | Full door and hardware install, sized and hung for your opening |
What pushes a job toward the top of its range? A heavier door or a double-wide opening, an older assembly where fasteners have seized, or a repair that turns out to be two problems stacked on top of each other (a cable that snapped because a roller had been dragging for months, for instance). What keeps it near the bottom? A single failed part on a door that’s otherwise sound, or a service call that catches the issue early. A matched pair of springs is replaced together, so that job costs about double the one-spring figure, which is the single most useful thing to know before you call.
If you want to understand how a specific job is priced in more depth, the garage door repair cost guide walks through repair-only scenarios, while the garage door spring repair page covers the spring-specific numbers in more detail.
What Affects Garage Door Pricing in Kenmore
Kenmore isn’t a generic market, and a few local realities shape what a job costs here.
- Door size and weight. A standard single-car door is lighter and cheaper to work on than a double-wide door, which needs heavier springs, more rollers, and more labor to move and adjust safely. Most Kenmore homes fall somewhere in between, and the written estimate reflects your actual opening.
- Brand and part availability. When a door or opener is from a brand a technician already knows, the job goes faster. We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, which means fewer delays waiting on a part and less guesswork on compatibility. An unusual brand outside that list can add time.
- Age of the door and opener. Older gear tends to fail in clusters. A door that came with the house often has original springs, original cables, and a tired opener all at once, so one repair reveals a second. We tell you what we see and quote the whole picture honestly rather than fixing one thing and leaving the next failure for a week later.
- Type of opener. A basic chain-drive opener is straightforward to repair or replace. A smart opener with Wi-Fi, battery backup, and app control takes more time to configure, which nudges the range up. Remote and connectivity troubleshooting on the major brands is within our scope, so you’re not sent to a different company for the electronics.
- Whether it’s a repair or an install. Repair keeps most of the existing door and typically stays in the lower bands. Installation means removing the old door, hanging a new one, balancing it, and retesting every safety feature, which is why it sits in its own range.
- Damage that was hidden. A dented panel is one thing. A panel that’s dented and has taken the track out of alignment is another. When wind or a hurried backing-out job bends a section, the panel and the track often need attention together, and that combination is priced as two line items.
Repair or Replace: Which Makes More Sense?
If the door still runs but one component has failed, repair almost always costs less, and a spring or cable replacement gets you back to a working door for a fraction of a new install. Replacement starts to make sense when the door has multiple failed sections, the opener is old enough to be unreliable, and you’d be paying for several repairs in a row. As a rough guide, if the repair estimate climbs toward the lower end of the installation range and the door is already worn, replacing it outright is worth considering. We’ll lay both paths out in the written estimate so you can compare them side by side. Call (833) 508-9224 and we’ll talk through which way your door is leaning.
Springs deserve their own note here. They’re the most dangerous component in the system, holding the full weight of the door under high tension, and a DIY fix on a torsion spring can cause serious injury. Our technicians have up to 13 years of experience, and spring repair is a dedicated service for exactly this reason: it’s work that most handymen won’t touch, and rightly so. If your spring is broken, leave it to a trained professional. The same goes for any repair that involves the cables or the door’s balance. We handle it so you don’t have to.
How to Save on Garage Door Repair in Kenmore
The most reliable way to keep the bill down is to call at the first sign of trouble rather than the second. A door that shudders or groans is telling you a roller is dragging or a cable is slack, and catching it early means a smaller job. Here’s what else helps:
- Catch it early. A slow-sticking door is cheaper to fix than one that’s snapped a cable because a roller failed first.
- Fix the actual cause. A remote that won’t work might need a new battery, not a new opener. We diagnose before we quote, so you’re not paying for parts you didn’t need.
- Bundle related work. If a technician is already out to replace rollers and the cables are showing wear, replacing both in one visit usually costs less than two separate calls.
- Ask about a matched pair up front. If one spring has failed, the second is usually on the same clock. Replacing the pair together saves a second call later.
- Get the written estimate. It’s free, and it lets you compare options before any work begins.
If your door needs attention today, call (833) 508-9224. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. We’re closed Saturday, and estimates are always free.
Why Brand-Specific Service Keeps Costs in Check
Garage doors and openers aren’t interchangeable, and a technician who’s already familiar with your hardware spends less time figuring things out. That’s why we service the major brands by name. A Clopay door and a Wayne Dalton door have different panel profiles, which changes how a panel replacement is priced. A LiftMaster opener and a Genie opener have different logic boards, which changes how a connectivity problem gets diagnosed. The garage door opener repair page covers that side of the work, and the garage door installation page handles new-door projects, so one call covers it all instead of sending you between contractors.
For homeowners who want a full new door, the garage door services overview shows how installation, repair, and opener work fit together, and the emergency garage door service page explains how we handle a door that won’t close when you need it secured tonight.
FAQs – Garage Door Cost in Kenmore
How much does garage door repair cost in Kenmore?
Garage door repair in Kenmore typically runs $150 – $600, depending on which part has failed. A single spring is usually $180 – $340, cable repair is $130 – $250, and opener repair is $120 – $320. Call (833) 508-9224 for an exact quote; estimates are free.
How much does it cost to replace a broken spring?
A single broken spring typically costs $180 – $340 to replace in Kenmore. If both springs are replaced together, which is common because they wear on the same schedule, expect about twice that. Call (833) 508-9224 and we’ll confirm what your door needs.
Is it cheaper to repair or replace my garage door?
Repair is almost always cheaper when the door is otherwise sound, and a single component fix usually lands between $150 and $600. Replacement typically runs $700 – $2200, so it makes sense when several parts have failed at once. Call (833) 508-9224 and we’ll quote both options.
How much does a new garage door installation cost in Kenmore?
A new door installation in Kenmore typically costs $700 – $2200, with the range driven by door size, material, and opener pairing. The written estimate sets the final price. Call (833) 508-9224 for a free quote.
Do you charge extra for same-day or urgent service?
No. The price is set per job by the written estimate, and same-day scheduling doesn’t add a premium. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Call (833) 508-9224 to get on the schedule.
Contact Us for a Free Kenmore Garage Door Estimate
Whatever’s going on with your door, a quick phone call gets you a straight answer and a written estimate before anything starts. Call (833) 508-9224 for a free estimate today. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Whether you need a spring replaced, an opener diagnosed, or a whole new door, one call covers it all. Back up and secure tonight, and know exactly what it costs before we begin.
Pricing reflects the Kenmore market as of 2026. Renton Garage Door Repair Pros offers free estimates – call (833) 508-9224.
What Our Customers Say
"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Cole Schaefer"Opener works, remotes are programmed, no complaints on the work. Took three days to get on the schedule though, so if you've got a car trapped inside, say so when you call."
- Amanda Barrett"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Jason Ackerman